Air Wave Soldering SystemGAW Series
- Standard built in spray fluxer
- TAMURA’ s GLOBAL STANDARD Model
- Spray fluxer is built into equipment with special low-pressure nozzle.
- Top and bottom exhaust filter minimize flux spread contamination.
- 1.5m long powerful far infrared pre-heater
- Titanium solder bath provide energy saving with double layered heat insulations.
- Independent inlet insertion conveyor
- Fluxer automatically adjust spraying to follow the conveyor speed and width.
- Sirocco fan is used for fluxer forced ventilation.
- Flux liquid shortage detect function
- Solder bath overheat detector is built in.
- Variable conveyor angle by 4-5 degrees
- Proportioning pump method, flux supply
- Electric bath lifter, motored pulling out
- Claw washer liquid shortage detection
- Intermittent solder jet
- Solder shortage detector
- Solder inner bath leak detection
- PCB warp prevention in solder bath block
- Exterior color can be specified
- Automatic supply of wire solder
- 3-color signal tower
- Outlet conveyor
- PCB cooling fan（with variable air flow and direction）
Specifications for equipment
||MAX W330×L350×t1.6 (mm)
MIN W 50×L120×0.6 (mm)
||Upper MAX. 150mm or lower
Lower MAX. 6mm or lower
|Input Power source
||AC380V±10%-50Hz-3φ 32kVA 49A
||4 ~ 5°
|Dimensions of machine
- ※Specifications are subject to change without prior notice. Please acknowledge it beforehand.
- ※1Except inlet and outlet sprockets
- ※2Except Exhaust Duct, Signal Tower and LCD Monitor
All kinds of other size variations are available
Select from Other Product